To install the Tax Table Update, follow these steps:

1. 2008 Tax Table (1.82 MB). The File Download dialog box will appear.
   Note: This TTU needs to be installed from the original computer that was used to install/upgrade Sage MAS 90 or MAS 200. 
2. To install the TTU on the current workstation, select Open (or Run this program from its current location).
   If a Security Warning dialog box appears, select Yes.
   If you're not installing on the current workstation, select Save and save the 2008Q1TTU.exe program to a location that can be accessed by the workstation to be upgraded. Then run the 2008Q1TTU.exe program from the workstation to be upgraded.
   Note: Do not save the program to a floppy disk.
3. Make sure no one is using Sage MAS 90 or MAS 200 and that all sessions are closed.
4. When the Welcome to the Install Shield Wizard for Tax Table Update screen appears, select Next.
5. Select Yes to accept the Licensing Agreement.
6. If the destination folder is correct to your Sage MAS 90 or MAS 200 installation, select Next.
   If the destination folder is incorrect, select Change and locate the folder above the ..\mas90 folder, and click OK.
   Once the correct location has been established, select Next.
7. Again, verify the current settings are correct, then select Install.
8. When the message InstallShield Wizard Complete appears, click Finish.
9. Start Sage MAS 90 or MAS 200. The following message will flash on the screen when you re-enter Sage MAS 90 or MAS 200: Installing TTU.
10. After re-entering Sage MAS 90 or MAS 200, you can verify the installation completed successfully by reviewing the Installed Applications Listing in Library Master. If the TTU installed correctly, you will see "2008-Q4 Tax Table" displayed on the Installed Applications Listing.

 *If you receive this error message: